10.6. Parking brake

Check and adjustment
Pull for the lever of the parking brake and be convinced that full inclusion happens between 7 and 9 clicks.
Launch the engine, press a brake pedal two-three times and stop the engine.

Fig. 10.15. Adjustment of the course of the lever of the parking brake


Remove a casing of the parking brake and the screw-driver turn an adjusting nut until the course of the lever is not in the required limits (fig. 10.15). The control lamp of the parking brake in a combination of devices has to light up after a lever inhaling on one click.
Lower the lever of the parking brake and be convinced that back brakes do not slow down the car.

Removal and installation of knot of the parking brake
Remove a casing of the parking brake.

Fig. 10.16. Elements of knot of the parking brake: 1 – screw; 2 – adjusting nut; 3 – handle; 4 – button; 5 – returnable spring; 6 – knot of the parking brake; 7 – screw; 8 – socket of the switch of a control lamp of the parking brake; 9 – bolts


Disconnect the socket from the switch of a control lamp of the parking brake (fig. 10.16). Turn off an adjusting nut.
Turn out bolts, disconnect the parking brake, a cable and lift assembly of the lever for extraction it from the car.
Examine the gear sector and a doggie of a ratchet on existence of damage of teeths and check elasticity of a returnable spring. Replace the damaged elements new.
Before installation grease the gear sector and teeths of a ratchet with lubricant of white color on a lithium basis.
Installation is carried out to the sequences, the return to removal.
Adjust the parking brake.

Removal and installation of the drive of the parking brake
Back cable
Lift a back part of the car and reliably fix on supports.
Remove a cable clip.
Remove assembly of brake shoes and disconnect a cable from the lever of the drive of a brake shoe.

Fig. 10.17. Back cable of the parking brake: 1 – bracket; 2 – bolt;
3 – adjusting nut; 4 – back cable of the parking brake; 5 – a cable connector with the lever of the drive of a brake shoe


Turn out bolts and an adjusting nut, remove a back cable of the parking brake from the car (fig. 10.17).
Installation is carried out to the sequences, the return to removal.
Before installation apply lubricant of white color on a lithium basis on the condensing cable ring. After installation turn an adjusting nut until the compensator is not located at an angle 90 ° to a forward cable of the parking brake.
In case of need adjust the course of the lever of the parking brake.
Forward cable
Remove a casing of the lever of the parking brake. Turn off and remove an adjusting nut.
Lift a back part of the car and reliably fix on supports.
Take a forward cable from under the car, disconnecting a back cable from the compensator.
Installation is carried out to the sequences, the return to removal.
In case of need adjust the course of the lever of the parking brake.