12.4. Trunk lid

Open a trunk lid and mark with a marker the provision of nuts of fastening of loops of a trunk lid.
Ask two assistants to support a trunk lid in open situation, turn off lock nuts and remove a trunk lid from the car.
Installation is carried out to the sequences, the return to removal. With two assistants establish a trunk lid and by hand screw lock nuts.
Close a trunk lid, check its provision of rather adjacent surfaces and if it is necessary, adjust its situation, then finally tighten nuts.

Trunk lid lock
For access to the lock remove the decorative panel of an upholstery.
On cars with a body the sedan or a compartment remove a safety lock.

Fig. 12.5. Elements of fastening of a cable and lock of a trunk lid: And – models with bodies the sedan and a compartment; In – models with a body the hatchback


For access to a cable of the drive of the lock turn out bolts and take the lock aside (fig. 12.5).
Disconnect a cable and draft of the drive of the lock and remove the lock from the car.
Installation is carried out to the sequences, the return to removal.

Shock plate of a trunk lid
For access to a shock plate of a trunk lid remove the decorative panel of an upholstery.
Mark with a marker the provision of bolts of fastening of a shock plate of a trunk lid.
Turn out bolts and remove a shock plate.
Installation is carried out to the sequences, the return to removal. If necessary adjust the provision of a shock plate. It can be made, tightening or weakening bolts until the necessary provision of a trunk lid is reached.

Mechanism of opening of a trunk lid and cover of a bulk mouth
In interior of the car for access to bolts of fastening of the squeezing lever remove a slip, extend clamps and turn off a carpet.
Turn out a bolt and disconnect a cable from the lever.
In a back part of the car for access to mechanisms of opening remove the decorative panel of an upholstery.
Disconnect a cable from the luggage carrier lock.

Fig. 12.6. Elements of fastening of a cable to a cover of a bulk mouth: 1 – nut; 2 – arm


Disconnect a cable of a cover of a bulk mouth from an arm and pull for a cable to open a cover. Turn off a nut and disconnect a cable (fig. 12.6).
Attach a thin cord to a cable of opening of a trunk lid and/or a bulk mouth and extend a cable in interior of the car. The cord will be required for retraction of a new cable into place.
Tie a cord to a new cable and involve it into place.
Further installation is carried out to the sequences, the return to removal.