13.8. Radio receiver

Removal and installation of the radio receiver 

Fig. 13.37. An arrangement in the car of the radio receiver, loudspeakers and wires: and – for cars with bodies the sedan and a compartment; b – for cars with a body the hatchback; 1 – the antenna installed in a body rack; 2 – forward loudspeakers; 3 – radio receiver; 4 – back loudspeakers; 5 – the antenna with the amplifier


The arrangement of the radio receiver, loudspeakers and wires is shown in fig. 13.37.
Disconnect a wire from the negative plug of the rechargeable battery.
Remove side panels of the radio receiver.
Turn out screws of fastening of the radio receiver.
Extend the radio receiver and disconnect from it contact sockets.
Remove the radio receiver from the dashboard.
Installation is carried out to the sequences, the return to removal.

Removal and installation of loudspeakers 
Back loudspeakers can be removed after opening of a luggage carrier. For access to forward loudspeakers it is necessary to remove a casing of loudspeakers.
Turn out screws, take the loudspeaker from a nest, disconnect the socket and remove the loudspeaker from the car.
Installation is carried out to the sequences, the return to removal.

The antenna with the amplifier

Fig. 13.38. Basic elements and an arrangement of the antenna with the amplifier on the car: 1 – amplifier of the antenna; 2 – antenna mast; 3 – antenna drive engine; 4 – antenna relay; 5 – antenna wire; 6 – arm


Basic elements and arrangement of the antenna with the amplifier on the car are shown in fig. 13.38.
Remove the lower facing of the dashboard, a ware box, an air duct of a heater and the fan of a heater.
Remove a side upholstery and disconnect an antenna wire, but not a wire of food.
Remove an antenna engine arm together with the engine and a mast of the antenna.

Fig. 13.39. Installation of the screw-driver in a mast of the antenna and movement up for removal of the antenna


For removal of the antenna at first insert the screw-driver into an opening in a mast of the antenna and extend the antenna approximately on 1,5 cm, as shown in fig. 13.39.

Fig. 13.40. Connection of the rechargeable battery to contacts "In" and "BG" of the socket (1) for an antenna pulling


Give tension from the rechargeable battery to contacts "In" and "BG" of the socket and extend the antenna from the engine (fig. 13.40).
Turn out two screws of fastening of the antenna to a rack of a body of the car and remove an antenna mast from the car.

Fig. 13.41. Connection of the rechargeable battery to contacts "In" and "BG" of the socket (1) for retraction of the antenna


Install the antenna on a body of the car and insert a gear strip of the antenna into an engine opening. For retraction of the antenna in the engine give tension from the rechargeable battery to contacts "In" and socket "BG" (fig. 13.41). Insert an antenna mast into an engine opening before fixing by its latch.
Install the engine and an arm.
If the antenna does not leave completely, turn the antenna engine several times automatically to adjust a tension of a gear strip of the antenna.